0309
TTPM2 Technical Specification
19
!L3
Loads document through front entry
!L4
Ejects document through front entry
!L5
Transports document to waste bin (only for printers with front load 2 and 3)
!L17
Selects lower rear document entry and signals if paper is out (for units with dual
consecutive entries
4
)
!L18
Selects upper rear document entry and signals if paper is out (for units with dual
consecutive entries
4
)
!T
Sets timeout for retract function
1
7.2.3
Print-parameter related commands
!F T
Print text
!F G
Print graphics
!F C
Print bar code
!F M
Specifies No. of r cancellation text to be printed if encoding fails
7.2.4
Magnetic encoding/decoding related commands
!D
Reads and decodes data in ISO format from track 2 (or center track)
!D1
Reads and decodes data in ISO format from track 1
!D3
Reads and decodes data in ISO format from track 3
!I
Defines data to be encoded in ISO format on track 3
!J
Defines data to be encoded in ISO format on track 1
!K
Defines data to be encoded in Hex format on track 1 or 3 (as applicable)
!M
Defines data to be encoded in ISO format on track 2 (or center track)
!N
Defines data to be encoded in hexadecimal format on track 2 (or center track)
!N+
Same as !N but reverses the bit order
3
)
!O
Reads data in hexadecimal format from track 2 (or center track)
1
Introduced in firmware version 3.75
2
!L1, !L2, !L17 or !L18
must
be selected on units with dual document entries
3
Added in firmware version xxxxx-332
