Troubleshooting
Before contacting SWEDX service or your
dealer, perform the following simple checks. If
you cannot solve the problem using the
instructions below, note the model and serial
number of your product and contact your local
dealer
Check that the mains lead has been
connected to a wall socket
Check that you have pressed the POWER
button on the front of the TV
Check the picture contrast and brightness
settings
Check the volume
Check the volume
Check whether the MUTE button has been
pressed on the remote control
Adjust the color settings
Check that the broadcast system selected
is correct
Try to identify the electrical appliance that is
affecting the set and move it further away.
Plug your set into a different mains socket
Check the direction, location and
connections of your aerial
This interference is often due to the use of
an indoor aerial
Replace the remote control batteries
Clean the upper edge of the remote control
(transmission window)
Check the battery terminals
Turn off the TV and unplug the AC cable
from the wall socket and then plug the AC
cable and turn on the TV
Check that the signal cable is firmly
connected to the source input
Check that the source is turned on
Check the maximum resolution and the
frequency of the video adapter. For HD
models the recommended resolution is
1366x768 and for Full HD models the
recommended resolution is 1920x1080
No sound or picture
Normal picture but no sound
No picture or black and white picture
Sound and picture interference
Blurred or snowy picture, distorted sound
Remote control malfunctions
“No signal” message is displayed
On PC mode, “Not Supported Mode”
message is displayed
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
The image is too lightor too dark
Pixel Mapping
l
l
Adjust the Brightness and Contrast
It is recommended to choose aspect ratio
JUST SCAN to achieve pixel mapping in
HDMI modes
Design and specifications are subject to change without notice.
20
