5.2 – LOCKING NUT IN PLACE
For both the front and rear lock nuts, find the appropriate lock washer tab that will fit into one of the
slots of the lock nut. Bend the tab into the lock nut slot, thus locking the nut in place.
SECTION 6– INSTALLING THE INFEED GUIDE AND FLYWHEEL
Figure 6-1: Install the infeed material guide. Figure 6-2: Make sure it rests against the knife.
Figure 6-3: Support flywheel over the shaft. Figure 6-4: Install the QD hub into the flywheel.
6.1 – INSTALLING THE INFEED MATERIAL GUIDE
Insert the material guide so that it rests on the stationary knife. Make sure banding cannot fit under
the guide after tightening.
AB033971
BN000538
BB000502
