TABLE OF CONTENTS
1. 510 FRONT AND REAR PLATE PREPERATION & INSTALLTION.
.........………….. 3
1.1 FACE PLATE BEARING RACE INSTALLATION……...................................... 3
1.2 FACE PLATE BEARING SEAL INSTALLATION..…………….......................…... 4
1.3 STATIONARY KNIFE SHIM INSTALLATION…………..…………………………….... 4
1.4 REAR PLATE BEARING RACE INSTALLATION…………..……………………………. 5
1.5 REAR PLATE BEARING SEAL INSTALLATION…………………………………………. 5
2. ROTATING KNIFE HOLDER INSTALLATION……
.............................................. 6
2.1 ROTATING KNIFE HOLDER AND SHAFT ASSEMBLY……………………………….. 6
2.2 SPACER PLATE INSTALLATION……………………………………………………………. 6
2.3 ROTATING KNIFE INSTALLATION……………………………………………………….. 7
3. FRONT AND REAR PLATE INSTALLATION
....................................................... 8
3.1 INSTALLING THE FACE PLATE…………………………..................................... 8
3.2 INSTALLING THE STATIONARY KNIFE.................................................... 8
3.3 INSTALLING THE ROTATING KNIFE HOLDER & REAR PLATE.................... 9
4 BEARING, SEAL, AND LOCKNUT ASSEMBLY.
................................................…. 10
4.1 INSTALLING REAR BEARING AND SEAL……………………………………………….. 10
4.2 INSTALLING THE REAR SPACER AND LOCKNUT……………………………………. 11
4.3 INSTALLING FRONT BEARING, SEAL, AND LOCKNUT……………………………. 12
5 SETTING THE KNIFE GAP……..
.......................................................................… 13
5.1 SETTING THE KNIFE GAP……………………………………………………………………. 13
5.2 LOCKING NUT IN PLACE……………………………………………………………………… 15
6 INSTALLING THE INTERNAL MATERIAL GUIDE AND FLYWHEEL
….…………….. 15
6.1 INSTALLING THE INTERNAL MATERIAL GUIDE…………………………………….. 15
6.2 INSTALLING THE FLYWHEEL………………………………………………………………. 16
