SECTION 1 – (cont.)
Figure 1-8: Rear plate and bearing race. Figure 1-9: Bearing race pressed into place.
Figure 1-10: Rear bearing seal (green).
1.1 - REAR PLATE BEARING RACE INSTALLATION
BN000283 must be pressed into CB006000 Rear Plate. Make sure the race is square to the plate prior
to pressing. The race should be pressed against the inside shoulder of the plate bore. Failure to seat
the race against the shoulder at this step will result in knife gap problems during final assembly.
NOTE: Earlier models use a rear plate that has a retaining ring instead of a machined shoulder. For
these models, make sure the race is pressed against the retaining ring.
1.2 – REAR PLATE BEARING SEAL INSTALLATION
Install the bearing seal on the inside bore of the rear plate. The seal cup should face the bearing race.
Insert until flush with the rear plate’s inside surface.
BN000282
CB006000
