3
CONDUCTOR
Swegon reserves the right to alter specifi cations
20090310
www.swegon.com
User
man
u
al
About CONDUCTOR
CONDUCTOR is a control system for regulating the room
temperature. You can create a comfortable indoor cli-
mate by keying heating and cooling settings in the room
unit. When you leave the room, the system automatically
regulates the climate until you enter a new temperature
setting.
Set to its automatic mode, the CONDUCTOR will regulate
heating and cooling in response to circumstances in the
room: is anyone in the room, is a window open, is the
room air humid?
These instructions describe how you as day-to-day user
of the CONDUCTOR, offi ce worker or hotel guest, can
regulate the heat and coolness in the room using the
room unit.
The parts of the room unit
Figure 1. The room unit.
1
Display
Shows the current status of the climate system and
information about the room temperature. It also shows
the settings you enter with the key set.
2
Key set
You can use it for changing settings of room tempera-
ture.
3
Temperature sensor
Placed inside the enclosure.
N.B.!
In that the measurement of the temperature is in-
fl uenced by the surroundings, the measurement of the
room temperature, dependent on where the room unit
is located, is not necessarily representative of the actual
heating or cooling requirements of the room.
To use the CONDUCTOR
The following section describes how you use the room
unit to adjust room temperature.
The key set
You use the key set to increase and decrease the desired
room temperature.
1
2
Figure 2. The key set.
1
The keys for adjusting the temperature
▲
UP
Increase the temperature.
▼
DOWN
Decrease the temperature.
2
Accept key for temperature
OK
CONFIRM
Confi rm the setting.
