PARAGON
d
2
Swegon reserves the right to alter specifications. 06/11/2021
Application area
The product is a comfort module designed for indoor
climate. The product is used to ventilate, cool and heat the
room.
The product may not be used for anything other than its
intended use.
General
Read through the entire instructions for use
before you install/use the product and save
the instructions for future reference. It is not
permissible to make changes or modify this
product other than those specified in this document.
Contents
1 PARAGON
1 Instructions for use
Protective equipment
Always use appropriate personal protective
equipment for the work in question, in the
form of gloves, respirators, protective glasses
and helmets during handling, installation,
cleaning and service/maintenance.
Electrical safety
Permitted voltage, see Electrical data.
It is not permissible to insert foreign objects
into the product’s contactor connections or
ventilation openings; risk for short circuiting.
24 V isolation transformer to be connected should comply
with the provisions of IEC 61558-1.
Cable sizing must be carried out for cabling between the
product and the power supply source.
Disconnect the power supply when working on products
that are not required to run.
Always follow the local/national rules for who shall be
permitted to carry out this type of electrical installation.
Handling
Always use appropriate transport and lifting devices when
the product is to be handled to reduce ergonomic loads.
The product must be handled with care.
Installation
• Moist, cold and aggressive environments must be
avoided.
• Assemble the product according to this instruction and
applicable industry regulations.
• Install the product for easy access during service/
maintenance.
• Avoid installing the product near a heat source.
• Check to make sure that the product does not have
any visible defects.
• Check that the product is properly secured after it has
been installed.
• Secure cables with cable ties.
• Check that all cables are properly secured in place after
installation.
Disposal
Waste must be handled according to local regulations.
Cleaning
Ideally the product should be cleaned twice a year by
vacuuming the coil to remove loose dust. In fibre dense
environments as hotels and ward rooms a first vacuuming
after three months is recommended and thereafter an
interval of 1-2 times a year. This is due to the fact that
new textiles often loose a lot of fibres in the beginning of
their life cycle.
A simple visual inspection of connections is recommended
when cleaning.
On painted surfaces such as grills: Avoid aggressive cleaning
agents which may harm painted surfaces. Normally a mild
soap or alcohol solution is fully adequate for cleaning. See
also the maintenance section in this instructions for use.
Service/maintenance
• In connection with a service, mandatory ventilation
inspection or cleaning of the ventilation system, check
that the general condition of the products looks ok.
Pay particular attention to the suspension, cables and
that they sit firmly in place.
• It is not permissible to open or repair electrical
components.
• If you suspect that the product or a component is
defective, please contact Swegon.
• A defective product or component must be replaced by
an original spare part from Swegon.
Product warranty
The product warranty or service agreement will not be in
effect/will not be extended if: (1) The product is repaired,
modified or changed, unless such repair, modification
or change has been approved by Swegon AB; or (2) the
serial number on the product has been made illegible or
is missing.
