EN.TBLZ475.190701
Swegon reserves the right to alter published specifications without notice.
2 www.swegon.com
4. Function
4.1 Start screen
The motor control system’s function selector switch should
normally be set to position 1 for control 0-10 V, but if the
fan is to be controlled or settings are to be made via the
hand-held terminal, the function selector switch should be
set to position 0.
If the screen lock is enabled, press on the screen once to
open the start screen.
The start screen provides access to basic functions, for
example, fan speed, type of drive, supplied power and
type of control. Enabled alarms and warnings are shown
at the top of the screen. An alarm clock shows that an
alarm is enabled. A warning sign shows if there is an
active warning. Press the alarm clock or warning sign to
navigate to the list of alarms/warnings.
To change set point values, press “Set point” on the start
screen.
The fan icon shows if the fan is running or stopped. Press
the fan icon to start or stop the fan.
4.2 Menus
To access the settings menu, where you can read and
change settings, press on the menu icon in the top right
corner of the start screen.
The hand-held terminal’s setting menu contains the fol-
lowing:
• Status:
Motor control system’s operating parameters can be
read.
• Drive setup:
Motor control system’s operating parameters can be
set.
• User settings:
User specific settings can be changed.
• I/O:
Digital inputs and outputs can be configured.
• Warnings and alarms:
Active warnings and alarms can be read.
• Modbus:
Modbus settings for motor control system
• Configuration:
The motor control system can be configured.
• Software:
The software version can be read.