4
§4 Operation
4.1 Layout Of The Front And Rear Panel
S c h w e i s s t e c h n i k
4
40
SKY
CUT
A
30
20
40
CUT
TEST
su p e r c u t c a p a c i
t y
SWEISSWELD.COM
11
10
9
8
7
6
5
4
3
2
1
1.
power pilot lamp
turn on power, the lamp on
2.
over-current ,over-heat alarm
when over-heat, over-current, the lamp would be on.
3.
cutting gun improper installation and air pressure low alarm
(1)when short circuit occurred between the electrode and the nozzle for abnormal reasons, the lamp on , air
feeds intermittently.
(2)when cutting gun with no electrode and nozzle installed, the lamp on, air feeds intermittently .
(3)when the Shield Cup is not installed, the lamp flashes.
(4)when the air low, the lamp on
4.
voltage pilot lamp
turn on the switch of the cutting gun, generate the voltage, the lamp on
5.
cutting current regulator
it is used to regulate the current when cutting.
6.
RUN/SET:
when cutting the workpiece, turn to the “RUN”; when doing gas test, turn
to the “SET”.
7.
Cutting gun connector
Summary of Contents for SKYCUT 440
Page 15: ...NOTES...
