SWEISS
WELD.COM
info@sweissweld.com
15
1.
Gas pipe not connected or pressure is too low, check gas connections. Adjust gas pressure to proper
setting.
2.
Faulty components in the unit, return for repair or have qualified technician repair.
B.
Low cutting output
1.
Incorrect setting of cutting current (A), check and adjust to proper setting.
2.
Faulty components in unit, return for repair or have qualified technician repair.
C.
Torch can cut but the cutting quality is poor
1.
Current (A) control set too low, increase current setting.
2.
The torch move too fast across the work piece, reduce cutting speed.
3.
Excessive oil or moisture in torch, hold torch 1/8 inch (3 mm) from clean surface while purging and
observe oil or moisture buildup (do not activate torch). If there are contaminants in the gas,
additional filtering may be needed.
4.
Lack of air pressure. Please check the air pressure and air flow, adjust it to the appropriate position
