©
2021 SwellPro All Rights Reserved
15
After 10 seconds, the drone will initiate an
in-place auto-landing to protect the drone
and battery. The front aircraft status
indicators are going to flash red
constantly.
During auto-landing, you can control the joystick to overwrite the auto-landing and regain
control of the drone. However, flying the drone below 14.2 V is highly dangerous since
the battery will not be able to maintain the flight and will result in the aircraft crashing.
⚠
During the flight, it is important to constantly monitor the battery level as flying in the
conditions like strong wind and rapid movements and heavy load can deplete the battery
more rapidly.
⚠
It is dangerous to continue flying the drone below 14.2 V. This could result in damage
to the battery and the risk of the drone crashing.
Waterproof Barometric Membrane
The waterproof barometric membrane is SwellPro’s featured technology. It allows air to
pass through the internal chamber of the aircraft to ensure the barometer
’s
proper
functioning
yet keeps the water from getting in to ensure the SplashDrone 4’s all
waterproof design. The waterproof barometric membrane is delicate yet an extremely
important part for proper flying and waterproofing. Therefore, you should pay special
attention to the proper use of waterproof barometric membrane during your operation.
•
Rinse the waterproof barometric membrane thoroughly with freshwater every time
after flying.
If the aircraft is not flying stably during hovering, or the aircraft is not flying normally
during ascend or descend, the waterproof barometric membrane might be damage.
Please take off the top barometric membrane cover and replace the waterproof
barometric membrane.
To replace the waterproof barometric membrane:
1.
Use a sharp tool (such as a knife) to remove the adhesive, then take off the top
cover.
2.
Peel off the old waterproof barometric membrane. Clean the surface barometric
vent and make sure there is no residue on the surface.
