©
2021 SwellPro All Rights Reserved
36
•
When the low battery level warning is activated, plan to return the drone and land
safely before the battery reaches a critical level.
•
The Return Home function can be used to reorient the drone towards the Home Point.
By activating the Return Home function, the drone will rise to the return altitude (20m)
and then turn towards the Home Point before starting its return.
•
If any obstacles are in the flight path of the drone during a Return Home process,
control should be regained by turning off the Return Home function.
•
If you crash your drone, lock the motors to prevent damage to the motors and
propellers.
•
Do not attempt to touch the motors, until the motors have stopped rotating completely.
•
When landing on water, avoid abrupt landings to avoid damage to the drone.
•
When flying over water, avoid the drone dropping or crash into the water from a high
altitude as this could cause major damage to the drone.
•
Do not expose the drone & battery to direct sunlight for long periods as this can raise
the internal temperature of the drone to well above the operating temperature range.
•
If the drone does not appear to be responding to the remote controller, as usual,
switch the drone to ATTI flight mode and fly the drone to a safe landing location.
•
The possible causes for the instability or loss of control of the drone could be poor
GPS signal, or poor radio signal, or weak Earth magnetic field.
•
If the drone appears to be affected by magnetic interference, try the following
remedies.
•
Re-calibrate both the compass and accelerometer on the SwellPro Fisherman.
•
After completing the calibration, arm the drone motors to fly in GPS mode to verify
whether this phenomenon has been eliminated.
•
If the abnormality remains the same, please re-locate to another place at least 5KM
away and re-calibrate the SwellPro Fisherman. Following the re-calibration, please test
the drone again.
•
If the problem persists, please contact SwellPro or your local dealer for further
troubleshooting and solutions.
Warranty Information
Please visit the SwellPro website
https://www.swellpro.com/news/after-sales-
Look for the "After-sales Service Policy" and submit a service request if needed.
Maintenance and Storage
⚫
After flying over the sea, sand, or water, the SwellPro Fisherman and modules must
be thoroughly washed with freshwater within 2 hours and dried - especially the
motors, gimbals, and camera.
