©
2021 SwellPro All Rights Reserved
26
Starting/Stopping Motors (Arming the Drone)
Before starting the drone, take the following precautions:
1. Place the aircraft in an open area 3 meters away from yourself and others. After the
aircraft is powered on, the system will conduct self-checking. After the self-checking is
completed, it will sound a confirmation tone.
2. Novice users should fly in GPS mode.
3. If the aircraft cannot be unlocked due to a week GPS signal, switch to ATTI mode to
unlock the aircraft. However, it is not recommended for novice pilots to fly in this mode,
as the location of the drone is not fixed when flying in this mode.
Starting (Arming) Motors
Remote controller operation
Description
Pull both the left and right joysticks simultaneously
down and inwards and maintain this position for 3
seconds. The motors will be unlocked and start
rotating.
Stopping Motors (Emergency Stop)
Remote controller operation
Description
Method 1: After the aircraft has landed on the ground,
pull the throttle to the lowest position, and hold for 3
seconds. The motor will be lock and stop rotating.
The recommended method for stopping motors.
Method 2: Pull both the left and the right joysticks
downwards and outwards. This method can be used
as an emergency stop.
⚠
Stopping the motors in flight may cause the drone
to crash and should only be carried out in an emergency
when stopping the motors will minimize potential
damage. (For example, there is a risk that the drone
