©2019 SwellPro All Rights Reserved
20
Alternating Green-Red fast flash
Green ON
WiFi ON
Camera in preview mode
Green slow flash
Camera recording
If this is your first time flying a drone, please read this manual thoroughly and watch the instructional videos
on our YouTube channel. We recommend taking professional training and guidance. When flying, select an
environment appropriate to your skills.
It is advisable for all drone pilots to become familiar with flying in
ATTI mode in case of GPS or magnetic interference, which can affect drone controls.
1. Although the Spry+ is waterproof, do not fly in heavy fog or if the wind is very strong or gusting above
Beufort Force 4.
2. Don't fly near metal frame walls or structures as this can affect the GPS and compass signals. It is
recommended to fly at least 10 meters away. Since the remote controller also has a GPS module inside,
please ensure the pilot remains 10 meters away from metal frame walls.
3. Flying in a complex electromagnetic environment, (e.g. boat) radio equipment may interfere with the
drone’s 2.4G signals which may cause the aircraft to react slowly or become uncontrolled. In these
situations, you can turn off the remote control for the aircraft to return automatically, or restart the
remote control, which can assist re-establishing control.
4.. When your drone is new, calibrate and fly several times over land to adapt the aircraft to the local
environment before flying over water.
5. When flying at altitudes above sea level, environmental factors including air density reduce the
performance of aircraft and therefore also the drone batteries.
6. When the temperature is below 10°C, the drone may not unlock. Power on the drone for a few minutes
to warm up and then the motors can be unlocked.
7. Normally, only the Compass Sensor needs to be calibrated when you have a new drone, check the
calibration section.
8. Aircraft does not support calibration on moving objects, such as boats.
9. Make sure the waterproof membrane is in good condition. The membrane prevents water from entering
the drone but allows air pressure to equalise the drone’s altimeter to operate correctly. Avoid touching
the membrane with your hands. If the membrane is dirty or completely soaked it will cause the altimeter
to work abnormally and the drone might not hover or fly well.
Camera Indicator
Flight
Basic flight knowledge
Summary of Contents for Spry+
Page 38: ...User Manual 2019 11 ...
