©2019 SwellPro All Rights Reserved
25
1. When taking off from choppy water, ascend quickly from the surface to prevent the drone being affected
by a passing wave.
2. When landing on water, descend vertically to the surface. If the drone lands with horizontal speed, it is
possible the drone can flip and be inverted. The flight controller will shut down the motors if the drone
becomes inverted.
3. Do not leave the drone floating inverted for more than a few minutes. If the drone becomes inverted on
the surface of the water, flip the drone by arming (unlock) the Spry+ and it will perform a Power Flip and right
itself on the water.
4. When the drone lands on water, it is normal for the remote controller screen to display “Gyro Calibration
Req”. This is due to the movement of the water and does not indicate that the gyro requires recalibration.
5. After landing on water, if the drone does not hover well, land the drone and dry the membrane as it may
have become saturated.
6. Always rinse the drone thoroughly after use on water and before salt crystalizes. Salt remaining on
membrane will severely affect the performance of the aircraft.
Water Take-off and Landing
7. The control distance of the remote control is affected by how far above the surface of the water the
controller and drone are. The higher the controller is from the water, the further the control and video
distance.
8. If the Remote Control is less than 2 meters above choppy water, the control distances of the drone will be
affected.
9. Once the drone lands on water, radio reception is affected, particularly if there are waves on the water
surface. Therefore, do not land on water unless the drone is closer than 100m. Video transmission is more
affected by water than the control signals. Video transmission from the drone floating on the water back to
the remote controller is limited to 30m.
Summary of Contents for Spry+
Page 38: ...User Manual 2019 11 ...