©2019 SwellPro All Rights Reserved
26
The Spry+ remote controller has a built-in WI-FI module that can be used to connect your mobile device and
control the aircraft to perform various intelligent automatic flight modes with the Spry+ APP.
APP installation: The Spry+ app is available for iOS and Andoid devices. Android systems can download the
APK from either the Android market or our website www.swellpro.com.
To connect the app to the Spry+’s remote controller, power on the remote controller and drone, then
connect your mobile device to the WiFi hotspot called SP_FF1.....
After successfully connecting, open the APP to display realtime data from the drone such as voltage,
coordinates, altitude, distance, GPS signal and other flight parameters.
When taking off from a boat there needs to be sufficient space, otherwise the drone should be placed on the
water for take-off. It is safer and easier to land the Spry+ on the water beside a boat rather than landing on a
rocking boat or where there is not enough space for a safe landing.
If the boat is rocking, the Spry+ may not
arm its motors in GPS mode. In this case, carefully take-off in ATTI mode and then switch to GPS mode if there
are sufficient satellites.
For safety, it is not recommended to launch or land your Spry+ from your hands.
Be aware of the direction of the wind relative to the boat. Even when at anchor, it is possible that the wind
will not be at the nose of the boat.
Always try and take off with the wind so that the drone will be taken away from the boat.
When landing the
drone onto a boat, if possible land against the wind so that the drone will be held away from the boat.
* When you are planning to fly the drone from a boat or a mobile platform ensure that the drone does not
require calibration before boarding as calibration cannot be performed successfully in an unstable location.
Take-off and Landing from a Boat
APP Control
Summary of Contents for Spry+
Page 38: ...User Manual 2019 11 ...