16
TR 600P / TR 750P / TR 950P / TR 1150P
D
ok
: 101502B
-GB 1442
TROUBLESHOOTING
Problem
Cause
Solution
The trowel does not
start.
1; Start switch in
off position.
2; Fuel cock off.
3; Fuel tank empty.
4; Cold engine
5; Engine faulty.
1; Turn the switch on.
2; Open the fuel cock.
3; Fill up the tank.
4; Activate the choke.
5; See engine manual.
The blades do not
rotate or rotate
too slow, when
the clutch handle
is activated.
1; TheV-belt is
broken.
2; TheV-belt is
slipping or does not
tension against the
pulleys.
3; The clutch wire
is broken.
4; The clutch is
broken
1; Replace the V-belt
2; Adjust the
tensioning of the
clutch wire.
3; Replace the clutch
wire.
4; Replace the
broken part or the
complete clutch.
The blade cross has
difficulty to rotate.
1; Cold engine.
2; To low r.p.m.when
activating the clutch.
3; Floating disc
is used and the
concrete is too fresh.
4; Engine faulty.
5; Gear box faulty.
1; Warm the engine
up at idle speed.
2; Increase r.p.m.
3; Wait until the
concrete has dried out
more.
4; See engine manual.
5; Repair or replace
the gear box.
The trowel is
shaking.
1; One or more
blades are bent or
faulty.
2; One or more
blades are not
moving in the hub.
3; The pressure
plate is askew.
1; Replace the
broken units.
2; Disassemble the
blades and clean the
contact area. Put
new grease on all
contact areas.
3; Replace the
pressure plate.
The blade
adjustment system
is out of order.
1; The blade
adjustment wire is
broken.
2; One or more of the
blades are not moving
in the hub.
3; The pressure
plate is not moving
vertically.
4; The blade
adjustment in the
operating handle is
faulty.
1; Replace adjustment
wire.
2; Disassemble the
blades and clean the
contact area. Put new
grease on all contact
areas.
3; Disassemble the
blade cross and clean
all contact areas.
4; Check all involved
parts and replace if
necessary.
