EQUIPMENT DET
AILS
112
A short co-ax lead featuring a screw on co-ax
connection will be present behind the Blue
mains inlet connector. A co-ax cable will be
fitted and connected within the motorhome,
from the back of this connection, to the
primary TV position within the motorhome. At
the same time, further co-ax cable or cables
will be fitted which route from a likely TV aerial
position (i.e. within the wardrobe) to each of
the TV positions within the motorhomes.
The primary TV position will feature a socket
marked 12v, TV, and SAT. The co-ax from
the external connection point will route to the
socket output marked SAT, whilst the co-ax
from the wardrobe or similar will route to the
socket output marked TV. At any secondary
TV positions, if present, the co-ax from the
wardrobe will route to the socket output
marked TV.
An external TV aerial or site TV feed can be
connected to the external connection point;
signals from that connection will then be
available at the primary TV position within the
motorhome. As the connections are of the
screw-on type, it is also possible to use this
co-ax to route from an externally mounted
satellite dish, to a satellite receiver.
Colour reference
The colour code for touch ups or resprays for
all white Fiat cab components is Fiat White
Bianco 549 silver cabs are Fiat Iron Grey 691.
Some dealer special cabs may have their own
colour specified from the Fiat standard range.
For Fiat cabs other than specified above
contact your dealer to obtain a colour match.
Please be aware that colours can fade over
time, and therefore, if the vehicle is more than
a few years old, it is suggested a colour match
be obtained.
Sliding Door Flyscreen (if fitted)
Operation
The sliding door flyscreen (if fitted) runs on
tracks mounted to the floor and the Control
panel and moves from left to right. It is
tensioned with cords that are fixed at floor level
near to the passenger seat.
When the vehicle sliding door is open pull the
blind from the central part of the vertical handle
avoiding twisting to close the blind.
Ensure flynet is open before closing the vehicle
sliding door.
Care
Clean only with a damp sponge ensuring dirt
build that would affect the running tracks is
removed. Use only clean water with mild suds
or a vacuum cleaner. In order to avoid material
fatigue, do not leave the flyscreen closed for a
long period. Take care with high winds when
the flynet is closed.
COLOUR REFERENCE / DOOR FLYSCREEN
Summary of Contents for Select 122
