21
Seat belts and legislation
Designated driver and passenger seats are
fitted with seat belts and MUST be worn when
travelling.
All children up to 135cm (4’5”) in height, or 12
years of age, whichever is reached first must use
a child car seat or booster seat suitable for their
age and weight.
Children over 135cm (4’5”) in height or aged 12
years and over must wear a seat belt.
Note: It is the legal responsibility of the driver
To ensure children aged up to 14 years old are
suitably restrained.
For passengers aged 14 and over, it is their
responsibility (not the driver) that a seat belt is
worn.
Seat belts are fitted for your safety and must be
worn unless a ‘Certificate of Exemption from
Compulsory Seat Belt Wearing’ is held. This
Certificate must be produced if asked for by the
Police – seat belt offences can result in a fine.
3.7 Child seats
Choosing/Buying
Go to a reputable retailer such as Halford’s, John
Lewis etc. Most reputable retailers will have
trained child seat advisers on site and will offer
a fitting service. Ask the advisor to fit various
seats to the vehicle. Once a correctly fitted
seat has been installed, satisfy yourself on it’s
suitability for your child and the vehicle before
buying as it is important to use a correctly fitting
seat in your campervan.
ISOFIX Child Seat Restraint
WARNING:
Use an anti-rotation device
when using the ISOFIX system.
WARNING:
Only child restraints certified
to ECE-R129 or ECE-R44.03 (or later) have
been tested and approved for use in your
campervan.
WARNING:
The child seat you use in your
car may not be suitable for mounting on a
campervan seat.
The two outer seats on the rear travelling bench
seat are equipped with ISOFIX anchorage
points. Each anchorage point is hidden behind a
small zipped area at the bottom of the seat back
cushion. Their locations are identified by an
ISOFIX lower anchorage label
The top tether anchor points are located on the
metal seat frame at the rear of the seat.
General Seat Installation Method:
1. Undo the zips at the base of the seat back to
expose the lower anchorages.
2. Place the child seat on the seat cushion and
push the child seat back firmly to engage the
ISOFIX lower anchor points
3. Route the tether strap over the back of the
seat to the anchor point and secure
4. Tighten the tether strap in line with the child
seat manufacturer’s instructions
WARNING:
Please consult with the child
seat manufacturer’s instructions for full
installation instructions. If in doubt please
consult the child seat manufacturers technical
support team for further guidance on the
installation.
WARNING:
Do not attach the top tether
strap to anything other than the correct top
tether strap anchor point.
WARNING:
Make sure that the top tether
strap is not slack or twisted and is properly
located on the anchor point.
WARNING:
Make sure the child restraint
rests tightly against the vehicle seat.
P
R
EP
AR
IN
G F
OR T
HE R
O
AD
Summary of Contents for MONZA CAMPERVAN 2022
