48
MV-1639-10-2021 . © Alle rettigheder forbeholdes Swim & Fun A/S
UK
TROUBLESHOOTING
Due to the individual characteristics of your pool, some adjustment may be required to get the best
possible performance from your pool cleaner. The following tips will help you to optimize the perfor-
mance of your cleaner.
Problem
Solution
Pool cleaner does not move, or moves slowly.
•
Make sure the main drain is dosed.
•
Check the Flow Control Valve and make sure the
flow to pool cleaner is sufficient.
•
Check diaphragm for wear or damage.
•
Backwash filter and empty pump strainer basket.
Pool cleaner gets stuck at steps or in a corner.
•
Fit Deflector Wheel.
•
Make sure total hose length is correct
•
Adjust return line eyeball fittings to use the water
flow to help guide away from the steps or corner.
Pool cleaner moves in a repetitive, non-random pattern.
•
Make sure return line fittings are directed dow
-
nwards. Check that hose weight position is correct.
•
Make sure total hose length is correct.
Pool cleaner stays in only one end of the pool.
•
Check the return line flow and redirect if necessary.
Check the total hose length and add more hose if
necessary.
•
Check that hose weight position is correct.
Air bubbles can be seen in the flow from the return line.
•
Check the hose to ensure there are no leaks. Check
the connection of the flow Control Valve, to make
sure it is underwater at all times.
•
Check the pump basket lid is fitted correctly, is not
loose or cracked and that no o-rings are worn or
missing. If necessary, contact your pool professional
for assistance.
Pool cleaner falls on its side.
•
Make sure the Outer Extension Pipe swivels freely.
Hose won’t fit Flow Control Valve.
• Fit Hose Adaptor to Flow Control valve.
ROUTINE MAINTENANCE
To maintain the performance of your pool cleaner:
• When removed from the pool, make sure the hose is stoved straight.
Never coil the hose
as
this may cause distortion which may adversely effect the pool cleaner.
•
Remove the Pool cleaner (including hose) before chemical treatment. Wait a minimum of 4 hou
-
rs after super chlorination (shock treatment) of your pool before re-installing the pool cleaner.
•
Clean the filter, skimmer basket and pump basket regularly.
•
When not in use, keep the cleaner disc flat, to avoid risk of warping.
• Periodically inspect your pool cleaner for signs of wear. If necessary, replace any worn parts.
NOTE:
Due to the harsh conditions in which your cleaner operates, it’s colour may fade and
discolor over time.
Summary of Contents for 1639
Page 85: ...MV 1639 10 2021 Alle rettigheder forbeholdes Swim Fun A S 85 PL...
Page 86: ......
Page 87: ......
