MV-1639-10-2021 . © Alle rettigheder forbeholdes Swim & Fun A/S
51
UK
Remove the RETAINING RING from the DIAPHRAGM. Discard the used diaphragm.
7.
a)
Fit the RETAINING RING ontp the new DIAPHRAGM.
Push the DIAPHRAGM onto the INNER EXTENSION
PIPE. Make sure it is correctly located and fully engaged.
b)
Pull the INNER EXTENSION PIPE up through the BODY,
positioning the tabs so they can be pulled through the
holes in the IEP LOCATOR.
c)
Gentle turn the INNER EXTENSION PIPE so the tabs are
aligned with the recesses in the IEP LOCATOR. Release
the INNER EXTENSION PIPE.
d)
Check that the DIAPHRAGM is correctly located. If it
has become twisted during installation, simply untwist by
slightly turning the open end of the DIAPHRAGM.
e)
Slide the THRUST WASHER over the INNER EXTENSI
-
ON PIPE. The flat side (widest diameter) of the THRUST
WASHER should face down.
f)
Place the OUTER EXTENSION PIPE over the INNER
EXTENSION PIPE.
g)
Screw the HANDNUT into place, to lock the assembly. Be
careful not to over-tighten the Handnut.
h)
Check that the OUTER EXTENSION PIPE swivels freely.
i)
Summary of Contents for 1639
Page 85: ...MV 1639 10 2021 Alle rettigheder forbeholdes Swim Fun A S 85 PL...
Page 86: ......
Page 87: ......
