SWIMMING POOL PUMP
INSTALLATION & OPERATING INSTRUCTIONS
WARNING: Read and follow all instructions in this manual and on the equipment. Failure to follow instructions can cause
serious injury or death.
WARNING: Electrical Hazard. Failure to follow Instructions can result in serious injury.
WARNING: Appropriately qualified and licensed personnel should install the pump and carry out the electrical connections.
WARNING: All electrical connections must be done by a qualified electrician according to local electrical standards.
WARNING: Pump should be wired to the main supply through an approved and correctly rated contactor and GFCI.
WARNING: Children and persons with reduced physical, sensory or mental capabilities, or lack of experience should not handle
and operate the pump. Fingers and foreign objects should be kept away from the openings and moving parts.
WARNING: Motor must be suitably grounded.
WARNING: The motor must be connected with other bonded parts using appropriately sized conductor using the bonding lug.
WARNING: Power supply voltage required by motor should correspond to that of the network and correctly sized cables
should be used to connect the pump motor.
WARNING: Disconnect the pump from the main power supply completely before servicing.
WARNING: Ensure that the appropriate precautions have been taken to prevent suction entrapment. A minimum of two
correctly sized suction points are required for each pump.
WARNING: Never run the pump dry! Running the pump dry damages the seals and bearings and can cause leakage and
flooding.
WARNING: Do not try to open the lid or service the pump while it is in operation.
WARNING: Do not use petroleum based lubrication for the plastic and rubber components as they will damage the
components and lead to failure.
