35
PB 8242-PB 8244
35
NEVER hang a swing seat by a
partial link of chain! Remove and
discard partial links.
Fig. 34
Fig. 36
Fig. 37
X. Swing Seat Assembly.
1. Hold the swing seat vertically and insert uncoated chains through
the channels on the bottom of the swing seat.
Note:
A coat
hanger may be used to help pull chain through the swing seat.
One full link should show at each end of the seat
(Fig. 34)
.
2. Place one covered chain onto each harness so that it fits at the top
of the V-hanger. Insert uncoated chains to bottom vinyl hooks of
V-hanger.
(Fig. 36)
. Crimp harness end closed.
CAUTION: It is important that you crimp harness
ends completely closed before using (see Fig. 36).
Place end of harness with hooks on a hard surface and force
hooks closed with a hammer or squeeze closed with a pliers
until parts are touching.
WARNING: Open hooks can
cause deep cuts.
3. Hang the chains from the nylon bushing swing hangers. Crimp the
hook opening closed with a pliers to secure the chains to the
swing hangers
(Fig. 37)
. Make sure all connections are tightly
crimped and secure before using swing seat.
Fig. 35
