Step 3 - Fitting the Lens (with LEDs) to the Painted Bumper
•
This is slightly tricky so take your time. Align the cone part of the lens to the bottom section of
the Bumper but with the Lens at an angle roughly 45-90 degrees and push lightly into place (do
not be forceful as the lens may crack). Alternatively you can cut off the bottom led mount and
fasten the white LED into the back of the conical section.
•
Then push the lens in and lift the lens so is vertical and carefully insert into the bumper - it will
catch slightly at the top of the bumper so wiggle and push at the main triangle lens and NOT via
the LED’s or LED’s mount points.
manual V-05
(5-10-22)
of
11
17
