Swisher E4-U3006, Owner'S/Operator'S Manual

Recommended 

Strap and Hanger

  Figure 10

P230, 231 
REAL EPS

7

Assembly

Press latch

With the pole pruner on a clean, flat surface, 

loosen the coupler screw. The spring-loaded 

coupler protector should pop up.
Press down on the latch with your finger 

or thumb. This releases the coupler lock. 
Pull the upper tube assembly out of the 

coupler.

1.

2.

3.

Disassembling the tube sections

Tool assembly

Lower tube assembly

Coupler

Latch

Coupler screw 

Knob

Locking hole

Latch protector (extended)

Slip off the protective covers from the 

ends of both tubes, and loosen the cou-

pler screw knob.
Insert the tool assembly into the cou-

pler, with the tool decal facing up, until 

the line of the decal is flush with the 

end of the coupler. 
Twist the tool assembly back and forth 

until you are sure it snaps in place by 

the coupler latch.
When the two tube halves are locked 

together, press down on the spring-

loaded latch protector and tighten the 

coupler screw knob.

2.

3.

4.

5.

Latch Protector (lowered)

Coupler Screw Knob

Coupler

Assembling tube sections

Place powerhead/lower tube assem-

bly on a clean, flat surface so that 

both assemblies fit end to end.  The 

powerhead/lower tube assembly 

should be facing positioned with the 

locking hole in the tube end facing up. 

1.

CAUTION!

Keep the open ends of the tubes 
clean and free of debris!

Strap and Hanger 

Although a strap and hanger is not 

required for with this unit, it is  recom-

mended to reduce operator fatigue during 

extended periods of operation.  Make sure 

all hooks and adjusting devices are secure. 

Adjust the harness shoulder strap so the 

shoulder pad rests comfortably on the off-

side shoulder. See Figure 10.

Optional Accessories

  Figure 8

  Figure 9

  Figure 7