FLOW CONTROL HANDLE
• Locate the Flow Control Handle on the operator
side of the Spreader as shown on
page 7.
• The Indicator Dial has marked intervals to
represent the amount of material that is
dropped while spreading. See
page 30
for
information on how to calculate the flow rates
for your desired medium.
• The Control Assembly has two indicator arrows
for the operator to select the desired flow rate.
The red arrow indicates a pre-set open setting.
The arrow on the Handle indicates the current
opener location.
FLOW CONTROL HANDLE OPERATION
• The Red Arrow indicates a pre-set value. This
position is selected by loosening the Black
Knob and moving the Indicator to the desired
setting.
• Once the Indicator Arrow is pointing to the
desired setting, tighten the Black Adjustment
Knob to lock handle stop in place. The Control
Handle will not be able to move past the pre-
set value.
14
FIGURE 14.1
CONTROL OPERATIONS
FIGURE 14.2
OFFSET ADJUSTMENT HANDLE
• Locate the Offset Control Handle located on the
Frame cross member as shown on
page 7
.
• The Offset Control Handle has an indicator
plate that reflects the direction the material will
be spread.
• When the Handle is set to the dot below the “R”
material will Spread a 90
°
Fan the “Right” side
as the unit is in operation.
• When the Handle is set to the dot below the “C”
material will Spread a Full 180
°
Fan pattern.
• When the Handle is set to the dot below the “L”
material will Spread a 90
°
Fan the “Left” side as
the unit is in operation.
OFFSET ADJUSTMENT HANDLE OPERATION
• Slightly loosen the Offset Locking Knob by
turning Counterclockwise. The knob only need
to be loosened enough to allow the Offset
Control Handle to move.
• Once the Knob is loosened, move the handle to
the desired spread direction as described
above. Retighten the Knob.
• The point located inside the handle viewing
cutout indicates the position of the Offset Plate.
FIGURE 14.4
FIGURE 14.3
Summary of Contents for HOBBY FARM PRO 22000
Page 34: ...34 When ordering replacement parts USE PAINT CODE TK BLACK NOTES...
Page 35: ...35 When ordering replacement parts USE PAINT CODE TK BLACK NOTES...
Page 36: ...36...
Page 37: ...37...