UNCRATING DIRECTIONS
1.
Using the required tools, remove the front
panel of the crate. The front panel is the
side of the crate that the hitch arms are
facing as shown in
FIGURE 9.1
. This is the
only side that needs to be removed for
uncrating the unit. The entire crate can be
disassembled if you choose, but it is not
required for assembly.
2.
After the front crate panel has been
removed, locate the hitch bars that are
bolted to the wooden block. This bolt will
be removed. See
FIGURE 9.2
3.
Have a second person hold the spreader
upright when removing this bolt.
Once
this bolt is removed the Spreader can
fall forward. Use Caution!
4.
Slowly Lower the Unit forward until it is
resting on the hitch arms.
5.
Follow the Assembly instructions on page
10.
6.
After the unit is assembled, remove the zip
ties holding it to the crate base.
7.
Remove the wheel chocks holding the front
of the spreader tires in place.
8.
The spreader can now be rolled out of the
crate.
9.
Check that all hardware is secure before
using.
9
FIGURE 9.2
UNCRATING
GENERAL RECOMMENDATIONS
•
Use at least two people to
uncrate & assemble the unit.
The Spreader and its
components are heavy.
•
Refer to
page 36
for
recommended hardware torque
values.
UNCRATING
•
Using a hammer and pry bar,
separate the crate side at the
front of the Spreader.
Use
caution to not damage the
equipment inside the crate.
•
Always wear gloves and safety
glasses when disassembling the
crate.
Use care
when
uncrating.
Wrench/Socket
Qty. Size
(2) 3/4”
Tools Required:
Pry Bar
Hammer
Safety
Glasses
Gloves
FIGURE 9.1
Summary of Contents for HOBBY FARM PRO 22000
Page 34: ...34 When ordering replacement parts USE PAINT CODE TK BLACK NOTES...
Page 35: ...35 When ordering replacement parts USE PAINT CODE TK BLACK NOTES...
Page 36: ...36...
Page 37: ...37...
