The unit is not cutting level.
•
Level deck. Check air pressure of all tires; make sure they are equal. See
tires for maximum inflation.
•
Without the engine running, make certain blades are installed identically.
The engine will not start.
•
Disengage blades, turn key switch to the “OFF” position, check battery and
all other electrical connections and inspect spark plug and wire.
•
Contact engine manufacturer or qualified mechanic.
Engine runs poorly.
•
See engine manual.
•
Check the throttle adjuster.
•
Replace fuel, check fuel filter and fuel line.
•
Check spark plug and gap.
Cutter bounces excessively while towing.
•
Decrease tire pressure.
•
Tow at a lower speed.
IF PROBLEMS PERSIST HAVE A QUALIFIED MECHANIC SERVICE
THE CUTTER. NEVER ATTEMPT TO MAKE AN ADJUSTMENT THAT
YOU ARE NOT SURE IS CORRECT. DOING SO CAN CAUSE OTHER
PROBLEMS.
9
GENERAL TROUBLESHOOTING
Summary of Contents for RC14544BS
Page 20: ...RECOMMENDED HITCH CONFIGURATIONS AND POSITIONS 20 FIGURE 15...
Page 21: ...21...
