11
2.
Loosen the adjusting screw on the miter gauge and adjust it flush with the edge of the square.
3.
Tighten the gauge adjusting screw, and verify the setting.
Note - Sometimes the tightening procedure can affect the adjustment.
4.
Loosen the screw that secures the angle pointer and adjust the pointer to the 0° mark.
5
.
Retighten the screw that secures the angle pointer.
To adjust the sanding belt angle
1.
Loosen the cap screw.
2.
Raise the sanding belt to the desired angle and tighten the cap screw.
To install the sanding belt
1.
Loosen the belt tension by pulling out the tensioning lever.
2.
Slide the belt onto the drive drums and release the belt tensioning lever.
Note!
Make sure that the arrow on the inside of the sanding belt points the same direction as the belt
rotation arrow on the machine.
Adjusting Sanding Belt Tracking
Warning! Before starting the sander, make sure you have performed the preceding assembly
and adjustment instructions, and you have read through the rest of the manual and are familiar with the
Belt
tension
lever