15
To install the table on the sanding belt bed:
1.
Raise the belt bed to vertical and remove the fence.
2.
Remove the disc sanding table.
3.
Place the index pin of the disc sanding table in the upper hole in the sanding belt table.
4.
Rotate the sanding table perpendicular to the sanding belt and screw in the lock knob.
MAINTENANCE
WARNING!
-
Before any repair or maintenance on the machine, disconnect the feeder cable. This has to
remain disconnected every time you set or repair the machine.
-
To prevent electrical shocks and fire, always use spare parts with the same characteristics.
-
Used, cut or damaged cables have to be immediately replaced.
To replace and tension the drive belt:
Disconnect the machine from the power source!
1.
Remove the drive belt cover plate.
2.
Loosen the three tensioning screws of the drive belt and slide the drive belt housing down and remove the
old belt.
3.
Place the new belt first on the lower drive pulley and then on the upper one. Lightly tighten the tensioning
screws.
4.
Insert a screwdriver into the adjustment opening and tension the drive belt by moving the screwdriver. After
that, tighten the three tensioning screws.
Drive
belt
housing
