10
NOTE:
Check blade height at both sides of blade.
- Tighten blade lock screws.
- Re-check blade adjustment and make sure blade is still level with outfeed table.
- Repeat the procedure to replace the other blade.
- Remove the scrap wood and release blade guard.
- Make sure all the blade lock screws are tight and snug.
NOTE:
- The blades which used with the tool may be replaced or re-sharpened.
- If the blades are resharpened, the re-sharpening should be not more than 3 times with 0,05 mm max. each
time.
- The blades used in this tool cannot be used to rebate.
ADJUSTMENT OF THE ROLLER HEIGHT
Before operation, you should adjust the height of roller, keep the roller base align with the machine base or
adjust the height of roller again making 0,2-0,4 mm higher than the height of machine base.
Use the wrench and hex, wrench key to loosen the nut again.
MAINTENANCE
WARNING:
Before inspection and maintenance, the switch of the machine must be turned “OFF“and the
power supply must be disconnected too.
CAUTION:
Some chemicals can damage the product. Do not use harsh chemicals like gasoline, carbon
tetrachloride, paint thinner etc.
CAUTION: A qualified repair technician must perform any tool service or repair.
Service or
maintenance performed by unqualified personnel could result in injury. Use only identical replacement parts. Use
of unauthorized parts or failure to follow maintenance instructions may create a risk of electric shock or injury.
Keep construction debris out of vents and switches by blowing with compressed air. If compressed air is
unavailable, please use a soft bristle or brush.
Use only mild soap and a slightly damp to clean the tool. Never let water or oil into the inside of motor.
CARBON BRUSH INSPECTION AND REPLACEMENT
WARNING:
Turn planer “OFF” and disconnect from power source. Carbon brush life depends on
amount of load on motor.
Regularly inspect carbon brushes after 100 hours of use. Brushes are located on either side of planer motor.
NOTE:
Carbon brushes are located on both front and rear sides of planer. Refer to Figure 8
Figure 8
A
B
Summary of Contents for ST-330 TP
Page 13: ...13 PART DIAGRAM ...
