SWISS TEC ST-330 TP, Operator'S Manual

3

WARRANTY

To ensure the proper functioning of its products, to meet the best standards of quality, durability and to ensure the 
consumer / retail customer that any of our products are of no defects in materials and operation of the DKSH 
Group is committed as follows 
1 YEAR WARRANTY ON ALL PARTS OF ELECTRICAL AND MECHANICAL
2 YEAR WARRANTY ON DEFECTS IN CONCEPT
This warranty will be invalid in case of misuse or abuse directly and indirectly, negligence, accidents, normal wear 
and tear, repairs or modifications made by us or in case of lack of maintenance.
The warranty granted by the DKSH Group is limited to the period referred to above.
The warranty period is for an 8-hour daily operation. If you exceed this time frame, the warranty period is reduced 
in proportion to the operating surplus, in each case up to a maximum of 3 months.
For the warranty to apply, you will need to send back for inspection by the product or part of it, prepaid, to an 
authorized service center, established by our office. The goods must be accompanied by a document certifying 
the purchase date and problem (invoice or receipt with a legible reported the item purchased, receipts will not be 
accepted or illegible entries generic as "different", etc. where section 1 of course cannot be identify with certainty 
the item purchased).
If as a result of our review will be found the defect, will repair or replace the product.
The  warranty  covers  only  the  value  of  the  machine,  even  if  any  failure  is  not  warranted  to  be  entitled  to 
compensation for loss of production or other economic losses related to non-use of the product itself.
We will then return the product repaired or replaced at the expense of DKSH same, but if as a result of control will 
not find any fault, or if the defect has been caused by reasons that are not covered by the warranty, the purchaser 
must bear the costs of filing and returning the consignment.
We reserve the right to make changes to parts, accessories and equipment, for any reason deemed necessary.

TECHNICAL SERVICE

All power tools and accessories are engineered and controlled by using the most modern and safe production 
techniques. Nonetheless, in case of malfunctions, your machine has to be repaired by a Service Center 
authorized by 

SWISStec.

SAFETY RULES

WHEN  USING  ELECTRIC  TOOLS.  ALL  THE  SAFETY  INSTRUCTIONS  SHOULD  ALWAYS  BE 

OBSERVED  TO  REDUCE  THE  RISK  OF  FIRE,  ELECTRIC  SHOCK  AND  PERSONAL  INJURY.  BEFORE 
ATTEMPTING  TO  OPERATE  THE  TOOL  PLEASE  READ  ALL  THE  INSTRUCTIONS  AND  SAVE  IT  FOR 
FURTHER REFERENCE

BASIC SAFETY PRECAUTIONS FOR ALL ELECTRIC TOOLS

(1) Keep work area clear
    - Cluttered area and benches invite injuries.
(2) Consider work area environment
    - Don’t expose electric tools to rain.
    - Do not use electric tools in damp or wet locations.
    - Keep work area well lit.
    - In particular, no inflammable liquids or gases must be present.
(3) Avoid electric shock
    - When you are operating tool, do not touch metal being grounded such as pipe, radiator, freezer etc.
(4) Keep children and visitors away
    - Don’t let children contact tool or extension cord. All visitors should be kept away from work place.
(5) Store idle tools