6 Troubleshooting
The
won’t switch on:
check the battery
condition.
The display flashes:
the battery voltage is too low –
replace the batteries.
The printer doesn’t work: c
heck that there is paper.
Check that the printer is switched on (initialisation menu,
printer). Note that the printer is automatically switched off
if the battery voltage is low.
The PC connection doesn’t work:
check the
connection cable between the
and the
PC is connected and that the transmission protocol
parameters are correctly selected (9600 Bauds, 8 data
bits, 1 stop bit, no parity) and that the correct COM port
is selected.
There is no display:
check the batteries are installed
and that the polarity is correct, then press and hold the
button until the end of the operation, during this
time press the
button briefly.
The external start and stop channels are not
working:
check – on the display – that they armed. Test
each input by creating a short circuit with a metallic
object (key or nail).
Menu access and operation impossible:
press the
RESET (located on the bottom of the device, just by the
START identification) with the tip of a pen. Note: this will
erase all results in the memory, and the setup process
will need to be repeated. However, the date and time are
not modified. The
will display the boot
program version (operating system of the
).
If the problems continue, please contact your nearest service
centre.
7
Accessories and options
The following accessories are available for the
(this list is not exhaustive):
C1
3361.603
Connection cable
C2
3361.628
Dual output adaptor for SCB & PC
C3
3361.626 SCB
adaptor
C4
3361.627
Adaptor for 2x SCB
C5
3361.605
Start & Stop connection cable
F1
3361.608
Extension box, 1xStart, 4x Stop or
3361.609
Extension box, 1x Start, 8x Stop
P2
3361.610
PC adaptor (RJ 6p – Sub-D 9pF)
S1
2872.003
Pushbutton with 3m coiled cable
3361.611
Swimming harness 1x Start, 8x Stop
9051.6042
Printer paper (1 roll)
9051.6042PK
Printer paper (20 rolls)
3449.961
GEMINI, 6 digits display using 7
segment amber LED digits (24cm)
or
3449.991
GEMINI, 9 digits display using 9
segment amber LED digits (24cm)
3456.901
Marathon clock single-sided display
using 8 segment amber LED digits
(16cm) See photo below. Or
3456.902
Marathon clock double-sided display
using 7 segment amber LED digits
(16cm)
3399.911
StartTime III, acoustic start system
230V. See photo below.
8 Cabling
diagram
Note
: To connect one of the extension boxes, you have to
open the battery compartment cover.
Computer connection (PC)
Scoreboard and computer
connection
Scoreboard connection
Connection of 2 scoreboards
(SCB)
- 18 -
- 17 -
- 16 -
