B. FillIing the Rinse Aid Dispenser
Rinse Aid Dispenser
The rinse aid is released during the final rinse, to prevent water from forming droplets on your dishes, which can
leave spots and streaks. It also improves drying by allowing water to run off the dishes. Your dishwasher is designed
to use liquid rinse aids. The rinse aid dispenser is located inside the door next to the detergent dispenser. To fill the
dispenser, open the cap and pour the rinse aid into the dispenser until the level indicator turns completely black. The
volume of the rinse aid container is about 110ml.
Function of Rinse Aid
Rinse aid is automatically added during the last rinse, ensuring thorough rinsing, and spot and streak free drying.
Attention!
Only use branded rinse aid for this dishwasher. Never fill the rinse aid dispenser with any other substances as this
will damage the appliance.
When to Refill the Rinse Aid Dispenser
If there is no rinse-aid warning light in the control panel, you can judge the amount of rinse-aid by the colour of the
optical level indicator located next to the cap. When the rinse-aid container is full, the whole indicator will be
dark .As the rinse-aid diminishes, the size of the dark dot decreases. You should never let the rinse aid get below
1 / 4 full.
C
(Rinse-Aid indicator)
As the rinse aid diminishes, the size of the black dot
on the rinse aid level indicator changes, as illustrated below.
Full
3 / 4 full l
1 / 2 full l
1 / 4 full - Should refill to eliminate spotting
Empty
1
2
3
1
To open the dispenser, turn the cap to "open" (left) arrow and lift it out.
2
Pour the rinse aid into the dispenser, be careful not to overfill.
3
Replace the cap by inserting it aligned with "open" arrow and turning it to the closed (right) arrow.
NOTE:
Clean up any rinse aid spilt during filling with an absorbent cloth to avoid excessive foaming
during
the next wash. Don't forget to replace the cap before you close the dishwasher door.
Adjusting Rinse Aid Dispenser
Adjust lever
The rinse aid dispenser has four to six settings. Always start with the dispenser
(Rinse)
set on "4". If spots and poor drying is a problem, then increase the amount of
rinse aid dispensed by removing the dispenser lid and rotating the dial to "5". If
the dishes still are not drying properly or are spotted, adjust the dial to the next
higher number until your dishes are spot-free. The recommended setting is "4".
(Factory value is "4".)
NOTE:
Increase the dose if there are drops of water or lime spots on the dishes after washing.
Reduce it if there are sticky whitish stains on your dishes or a bluish film on glassware or
knife blades.
6
