Notes:
- Inspect the filters for blockages after every wash.
- By unscrewing the coarse filter, you can remove the filter system. Remove any food particles and clean
the filters under running water.
NOTE:
The entire filter assembly should be cleaned once a week.
Cleaning the Filter
To clean the coarse filter and the fine filter, use a cleaning brush. Reassemble the filter parts as shown in the figures on the
last page and reinsert the entire assembly in the dishwasher, positioning it and pressing downward.
When cleaning the filters, please take care not to bend or damage these as this
WARNING!
could affect the dishwasher's performance .
Caring for the Dishwasher
The control panel can be cleaned by using a lightly dampened cloth. After cleaning, make sure to dry it thoroughly.
For the exterior, use a good appliance polish.
Never use sharp objects, scouring pads or harsh cleaners on any part of the dishwasher.
Cleaning the Door
To clean the edge around the door, you should use only a soft warm,
damp cloth. To avoid penetration of water into the door lock and
electrical components, do not use a spray cleaner of any kind.
n
Never use a spray cleaner to clean the door panel as it may damage the door lock
WARNING!
and electrical components.
n
Abrasive agents or paper towels should not be used because of the risk of
scratching or leaving spots on the stainless steel surface.
Protect against Freezing
Please take frost protection measures on the dishwasher in winter. After washing cycles, please do the
following
1. Cut off electrical power to the dishwasher.
2. Turn off the water supply and disconnect the water inlet pipe from the water valve.
3. Drain water from the inlet pipe and water valve (Use a pan to catch the water)
4. Reconnect the water inlet pipe to the water valve.
5. Remove the filter at the bottom of the tub and use a sponge to soak up water in the sump.
14
