Problem
Possible Causes
What To Do
The dishes
The dishes were not
See notes in " Loading the Dishwasher Baskets ".
are not clean
loaded correctly.
The programme was
Select a more intensive programme.
not powerful enough.
See" Wash Cycle Table ".
Not enough detergent
Use more detergent, or change your detergent.
was dispensed.
Items are blocking
Rearrange the items so that the spray can rotate freely.
the path of spray arms.
The filter combination
Clean and/or fit the filter combination correctly.
Unsatis
in the base of the wash
Clean the spray arm jets. See "Cleaning the Spray
cabinet is not clean or
Arms".
-factory
is not correctly fitted.
washing
This may cause
result
the spray arm jets
to get blocked.
Cloudiness
Combination of soft
Use less detergent if you have soft water and select
on glassware
water and too much
a shorter cycle to wash the glassware and to get
detergent.
them clean.
Black or gray
Aluminum utensils
Use a mild abrasive cleaner to eliminate those marks.
marks on dishes
have rubbed against
dishes.
Detergent left in
Dishes block
Re-load the dishes properly.
dispenser cups
detergent cups.
The dishes
Improper loading
Load the dishwasher as suggested in the directions.
are not drying
Too little rinse-aid
Increase the amount of rinse-aid/Refill the rinse-aid
dispenser.
Dishes are removed
Do not empty your dishwasher immediately after
Unsatis
too soon.
washing. Open the door slightly so that the steam can
-factory
escape. Begin unloading the dishwasher only once
the dishes are cooled off.
drying
Empty the lower
basket first. This prevents water from dropping off
result
dishes in the upper basket.
Wrong programme
In short programmes the washing temperature is lower.
selection
This also lowers cleaning performance. Choose a
programme with a long washing time.
Using cutlery with
Water drainage is more difficult with these items.
a low-quality coating
Cutlery or dishes of this type are not suitable for
washing in the dishwasher.
Error Codes
The appliance will display error codes to warn you of malfunctions:
Codes
Meanings
Possible Causes
E1
Longer inlet time.
Faucets are not opened, or water intake is
restricted,
or water pressure is too low.
E3
Not reaching required temperature.
Malfunction of heating element .
E4
Overflow.
Some element of dishwasher leaking.
Ed
Failure of communication between main PCB with TFT PCB Open circuit or break in wiring for the communication
If overflow occurs, turn off the main water supply before calling for service.
WARNING!
If there is water in the base pan because of an overfill or small leak,
the water should be removed before restarting the dishwasher.
20
