2. Quick operating guide
For detailed operating info, please read the corresponding content in the instruction manual.
Switch on the appliance
Press the Power switch button to switch on the appliance, Open the door.
Compartment A:
We recommend using powder
only
With each wash cycle.
C
Fill the detergent dispenser
Compartment
B:
For programmes with pre-wash only.
A
B
(Follow the user instructions!)
Check the rinse aid level
Mechanical indicator C.
Electric indicator on control panel (if provided).
(On models with water softener system only.)
Check the regeneration
Electric indicator on control panel (if provided).
salt level
If there is no salt warning light in the control panel
(for some models), you can estimate when to fill the salt into
the softener by the number of cycles the dishwasher has run.
Load the baskets
Scrape off any large amount of leftover food. Soften remnants of burnt food in pans,
Then load the baskets. Refer to the dishwasher loading instructions.
Select a programme
Close the door Press the programme button until the selected programme lights up.
( See the section entitled
“Operation instruction” )
Running the dishwasher
T urn on the water tap and press the Start/Pause button. The machine will start working
After about 10 seconds.
Changing the programme
1. A running cycle can only be modified if it has been running for a short time, otherwise the detergent
may have already been released and the water already drained. If this is the case, the detergent
dispenser must be refilled.
2. Press the Start/Pause button ,then press the program button for more than 3 seconds to cancel the
running programme. .
3. Select a new programme.
WARNING!
Add additional dishes into
4. Restart the dishwasher.
1. Press the start/pause button to stop the machine.
Open the door carefully.
the dishwasher.
2. Open the door.
Hot steam may escape
3. Add the forgotten dishes.
When the door is opened!
4.Close the door, then press the start/pause button, the dishwasher will
start running again after 10 Seconds.
If the appliance is switched
If the appliance is switched off during a wash cycle, when switched
Off during a wash cycle.
on again, please re-select the washing cycle and operate the dishwasher
according to the original power-on state).
When the working cycle has finished, the buzzer of the
Switch off the appliance
dishwasher will sound 8 times, then stop.
Turn off the appliance using the Power button.
The appliance will be on standby and will power off automatically after 30 minutes without any
operation.
Turn off the water tap,
Warning: wait about 15 minutes before unloading the dishwasher as they will be extremely hot.
unload the baskets
They will also dry better. Unload the appliance, starting from the lower basket.
2
