3
Setting up the handset for use
Handapparat Classic S112 / SWZ englisch / A31008-M1605-F151-7619 / main.fm / 08.04.2005
Setting up the handset for use
Fitting the battery pack
u
To open
the battery compartment, push
the tongue on the battery cover inwards
(see picture on left) and lift off the cover.
u
Fit the right side of the battery pack under
the clips then press down on the left side so
that the pack snaps home.
u
Plug the jack firmly into the socket
(see picture on right).
u
To close
the battery compartment, position
the cover and press until it snaps home.
Registering the handset on the
base
You must register the handset on the base in
order to make calls. The handset registers with
the base automatically when the Classic S112
handset is placed in the Classic S112 Base sta-
tion. If you want to use the Classic S112 hand-
set with another GAP base, you have to register
it manually.
Automatic registration:
Handset Classic S112 to
Base Classic S112
Important: the handset must not already be
registered to a base station.
Place the handset in the base with its
display
facing forward
. The automatic registration
takes about one minute. Throughout this
period of time, the display shows
Registering
and the name of the base, e.g.
Base 1
, blinks.
The handset will automatically be assigned the
lowest unassigned internal number (1–4).
When a successful registration is complete, the
following is displayed, e.g.
INT 1
. If the internal
numbers 1–4 are already assigned (four hand-
sets are registered with one base), the number
4 is overwritten, if this handset is in idle status.
Manual registration:
Handset Classic S112 to
Base Classic S112
On the handset
§Menu§
¢
Settings
¢
Handset
¢
Register Handset
~
Enter the system PIN of the base
station (the default is 0000) and
press
§OK§
. The screen will display,
e.g.
Registering
Base 1
.
On the base station
¤
Press the registration/paging key on the
base for approx. 3 seconds.
The registration process starts.
Manual registration:
Handset Classic S112 to other GAP bases
Other handsets are registered as follows.
On the base station
¤
Set the base up for registration
(s. user guide for base station).
On the handset
§Menu§
¢
Settings
¢
Handset
¢
Register Handset
~
Enter the system PIN for the base
(e.g. "0000") and press
§OK§
. The
screen will display, e.g.
Registering
Base 1
.
The registration process starts.
Notes:
– The battery wires must be situated so that the
battery cover does not catch the wires when it is
closed. The wires can otherwise be damaged
when closing the cover.
– Only insert the recommended rechargeable
battery pack
, i.e. never use a normal battery
pack as this could damage your health and cause
injury.
– Never use non-Siemens battery chargers as this
could damage the battery pack.
– The handset should only be placed in a base or
charging cradle that is intended for it.
