Then calculator state is updated from the selected file.
6.2.2. Save DM41 State File >
Used for saving calculator’s state to a
.d41
state file. By default to the
/STATE/
directory of the FAT
disk.
• Select file from list (for overwrite) or
<New File>
if you want to enter new filename.
Confirm with
[
ENTER
]
• [On
<New File>
] Enter new filename.
[
SHIFT
]
toggles input mode between lower/upper case
and numbers.
Confirm with
[
R/S
]
or
[
Alpha
]
.
Then calculator state is saved to selected file.
6.2.3. Load RAW Program >
Used for loading the
.raw
program file from FAT disk. By default from the
/PROG/
directory of the
FAT disk.
This is functional equivalent of
GETP
extended memory command. Only this reads from FAT disk
instead of extended memory.
To load program file:
• Select the program to load using the
[
▲
]
and
[
▼
]
keys
•
[
ENTER
]
to load the selected state file
The program is loaded into calculator memory.
6.2.4. Save RAW Program >
Used for saving program to a
.raw
file to FAT disk. By default to the
/PROG/
directory of the FAT disk.
This is functional equivalent of
SAVEP
extended memory command. Only this writes to FAT disk
instead of extended memory.
Note that the program name to save has to be prepared in ALPHA register.
• Select file from list (for overwrite) or
<New File>
if you want to enter new filename.
Confirm with
[
ENTER
]
• [On
<New File>
] Enter new filename.
[
SHIFT
]
toggles input mode between lower/upper case
and numbers.
Confirm with
[
R/S
]
or
[
Alpha
]
.
The program is saved from calculator memory to FAT disk.
13
