Babycom 143
45
Charging the batteries
If the batteries are almost discharged, the power display on the parental
unit flashes red and an alarm signal (3 short beeps) is emitted every 3
seconds. You must charge the batteries within the next 5 minutes;
otherwise the device will automatically switch off.
Note:
- Non-rechargeable batteries must not be charged up.
- Remove discharged batteries as they can leak and damage the unit.
- No alarm signal is emitted on the baby unit when the batteries are
discharged!
Test before use
Transmission from baby unit / reception on parental unit
- Place the units in the rooms where you want them to operate.
- Switch the units on: Press and hold the Power key for approx. 2
seconds. An acknowledgement signal is emitted and the power dis-
play lights up (green = batteries charged).
- Use the channel switch to switch the two units (parental/baby unit) to
the same channel (Channel 1 or 2).
- Set the same CTCSS code for both units: Use a pointed object (e.g.
pencil) to activate the microswitch and set the CTCSS codes (CTCSS-
Code = system for creating user groups on the same frequency).
There are 4 CTCSS combinations available, see "Table of CTCSS
Codes".
Summary of Contents for Babycom 143
Page 84: ...Babycom 143 82 ...
Page 85: ...Babycom 143 83 ...
Page 86: ...Babycom 143 84 ...
Page 88: ...Internet www swissvoice net Swissvoice SA 2009 20405469xx_ba_a0 SV 20405469 ...
