Test transmission from baby unit
- Use the sensitivity switch to set the preferred sensitivity level on the
baby unit. The volume display is activated (1 or 2 bars = low noise, 3
bars = loud noise). The baby unit is ready to transmit.
- As soon as the baby unit sends a signal, the green display is activated
and remains permanently lit. If the baby unit is not sending out a sig-
nal, the green display flashes and the unit is on standby.
Test reception on parental unit
- Use the VOL+/VOL- keys to set the preferred volume on the parental
unit. The parental unit is ready to receive.
- As soon as the parental unit receives a signal, the green display is
activated and remains permanently lit. If the parental unit is not
receiving a signal, the green display flashes and the unit is on standby.
Note:
- If you hear any disturbance on the units due to interference (hissing,
buzzing), change the CTCSS code on the parental and baby units.
See "Table of CTCSS Codes".
- Test reception on the parental unit before use and whenever you
reposition the baby unit.
- Position the baby unit at least one meter away from the baby.
- The maximum range between the parental and baby units is 300
meters.
Babycom 143
46
Summary of Contents for Babycom 143
Page 84: ...Babycom 143 82 ...
Page 85: ...Babycom 143 83 ...
Page 86: ...Babycom 143 84 ...
Page 88: ...Internet www swissvoice net Swissvoice SA 2009 20405469xx_ba_a0 SV 20405469 ...