Babycom 143
47
Settings
On/off
- To switch the units on: Press and hold the Power key for approx. 2
seconds. An acknowledgement signal (2 short beeps) is emitted and
the power display lights up (green = batteries charged).
- To switch the units off: Press and hold the Power key for approx. 2
seconds. An acknowledgement signal (1 short beep) is emitted and
the unit is switched off.
Setting the volume
Use the VOL+/VOL- keys to set the preferred volume. You have the
choice of 3 volumes. A control signal to check the set volume is emitted
when the device receives a signal.
Setting the channel
Use the channel switch on the left of the parental/baby unit to set the
preferred channel (Channel 1 or 2).
Note:
The parental and baby unit must be set to the same channel in order to
interconnect the units!
Setting the CTCSS code
Four CTCSS subchannels are available for a protected private sphere:
The receiver (parental unit) is activated only when it receives a signal
from its own transmitter (baby unit). It is therefore essential for the same
CTSS code to be set on the parental and baby unit so that they can
communicate.
Summary of Contents for Babycom 143
Page 84: ...Babycom 143 82 ...
Page 85: ...Babycom 143 83 ...
Page 86: ...Babycom 143 84 ...
Page 88: ...Internet www swissvoice net Swissvoice SA 2009 20405469xx_ba_a0 SV 20405469 ...
