26
Page
Version 1.1 December 2020
Step 19: Now secure the Camera Mount Housing Assembly (Parts D and E) with four 11mm M3 Screws. Put
all four in the housing and make sure they are all started into the threads before tightening the screws. Make
them tight, but don’t over tighten them. You don’t want to pull the Brass Inserts out of the housing.
Step 20: (Optional) Mount the Laser Air Quality Sensor (Part I) on the outside oriented as shown and route the
Grove cable (Part J (plugged into the Laser Air Quality sensor) into the SkyWeather2 Base Unit (Part B) using
11mm M3 screws.