Operating the Walkie−Talkies
71
P
Confirm selection and end baby
monitoring
If you use this function with a headset, deactivate baby moni-
toring by pressing the
P
button.
Transmitting the ringing tone
The ringing tones indicate to other subscribers that you want to talk to
them. A condition for this is that the other subscribers are using the
same channel and CTCSS code.
T
Send ringing tones
Selecting/Deactivating ringing tones
There are 10 ringing tones available for selection. To deactivate the
ringing tone, select the setting
[
OF
]
.
4 x
M
Open the menu
:
/
;
,
P
Select ringing tone and confirm it
Selecting squelch level
The squelch level determines the sensitivity of the audio signals to be
transmitted through the speaker. There are 4 levels for selection. With
setting 1, even weak signals are transmitted. With setting 4, only strong
signals are transmitted. Set the required setting to prevent unwanted
background noises being played through the speaker.
6 x
M
Open the menu
:
/
;
,
P
Select the squelch and confirm it
Scanning for a channel
Signals are searched for in the eight channels in a continuous cycle. If
an active channel is detected, the channel scan stops.
Press the
P
button to enable radio communication on this
channel.
If you do not press the
P
button, channel scanning is
resumed five seconds after no further signal has been
transmitted on this channel.
Press the
:
/
;
button to skip this channel.
Summary of Contents for WTF 730
Page 38: ...Notes 38 Notes...
Page 39: ...Notes 39 Notes...
Page 59: ...Appunti 59 Appunti...
Page 78: ...Notes 78 Notes...
