GOLIATH SENIOR
GOLIATH SENIOR
SPECIFICATIONS
Description
: 6x10 + Tweeter Speaker Enclosure
Power Handling
: 1000 watts RMS
Impedance
: 4 Ohms
Frequency Response & SPL
: 110 dB SPL @ 1W1M
(–3 dB @ 55 Hz and 14 Khz)
Speaker Complement
: (6) 10" P.A.S Drivers, (1) Foster Horn
Heavy-Duty Casters, Spring Loaded Rubber Grip Handles,
Bottom Slot Port, Top Handle and Tilt Back Design for easy
transportation.
Dimensions
: 23.25"W x 36.5"H x 18.5"D
Weight
: 115 lbs.
P.A.S 10" SPEAKER SPECIFICATIONS
Free Air Resonance
: 47Hz
Individual Impedance
: 8 Ohms (each)
Power Rating
: 175 Watts RMS (each)
CONNECTION AND OPERATION
Goliath Senior can be connected to any musical instrument amplifier capable of driving a 4 ohm load.
To connect your amplifier to Goliath Senior, run a high quality speaker cable (18 gauge or
heavier) from your amplifier’s speaker output to one of the designated speaker inputs (Speakon or 1/4")
on Goliath Senior’s input panel.
POWER HANDLING
The power output rating for any amplifier connected to Goliath Senior should not exceed the enclosure’s
1000 watt RMS power handling capacity. Please be aware that exceeding Goliath Senior’s power han-
dling capacity can void the SWR warranty if any damage occurs to your loudspeakers due to overpower-
ing.
FULL RANGE INPUT AND OUTPUT JACKS
Goliath Senior features four, full range input/output jacks (two standard 1/4" and two Speakon) wired in
parallel. If you are running two speaker enclosures in parallel, connect the speaker cable from your
amplifier to either jack labeled “IN,” and a second speaker cable from either jack labeled “OUT” to the
input of the second speaker enclosure.
TWEETER ATTENUATOR CONTROL
The large dial found on the input panel of the cabinet is the Tweeter Attenuator. This control is used to
adjust the level of high frequency signal present at the tweeter. A normal setting for this control is
straight up or “twelve o’clock.” Turning the dial fully counter-clockwise removes the tweeter from the cir-
cuit. As you turn the dial clockwise from this position, the high frequency content is increased.
INTERNAL CROSSOVER
Goliath Senior’s internal (passive) crossover divides the incoming signal into two frequency bands. The
crossover point is 5 kHz (frequencies above 5 kHz are sent to the tweeter, frequencies below 5 kHz are
sent to the 10" speakers).
BASS SPEAKER ENCLOSURES OWNER’S MANUAL • 11
