Table of Contents
A.
Component Placement . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
B.
Component Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
C.
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
D.
Startup Procedures . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7
E.
Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8
F.
Flow Diagram . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .10
G.
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .11
A. Component Placement
A.1 Faucet Placement
Proper faucet placement should ensure a no-splash waterfall pattern into the
sink. The faucet handle should normally be positioned to either the left or the
right of your existing faucet as one faces the sink.
A.2 Pressurized Storage Tank
In a typical installation, the closer to the faucet that the storage tank can be,
the better. If you locate the storage tank under the sink it should be placed so
that it can be easily removed from under the sink. Avoid placing the storage
tank in an out-of-the-way location. There are two reasons for this: First, the
difficulty of installation increases significantly; Second, when the storage tank is
located further away from the faucet, the flow rate decreases.
A.3 RO System Assembly Placement
The reverse osmosis system assembly bracket should be hung on a wall or sink
cabinet side wall with the two screws provided. Be sure to either:
3.1 Leave enough length of both blue and orange tubing so the system
assembly can be lifted off the mounting screws and removed from under
the sink for periodic cartridge replacement , or...
3.2 Leave enough bottom clearance to remove and replace the cartridges
from their respective housings after the housings have been unscrewed for
servicing.
A.4 Pressurized Storage Tank Placement
The storage tank can be placed anywhere within the vicinity of the reverse
osmosis system. It can be placed vertically or horizontally. It is suggested for
proper flow rate not to exceed placement more than 5 feet away from the
reverse osmosis system. If a distance of more than 5 feet from the reverse
osmosis system is required, larger tubing may need to be installed between the
storage tank and the reverse osmosis system.
B. Component Information
B.1 Filter Cartridges
Sediment Cartridges
Sediment cartridges are designed to remove large amounts of suspended
particals from water to help reduce the probability of clogging the reverse
osmosis membrane.
2
