SXT-SCOOTERS
BEFORE YOU BEGIN
Remove contents from box. Remove the foam separators that protect the components from
damage during shipping.
Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have
occured during shipping. Because the scooter is 95% assembled and packed at the factory,
there should not be any problems, even if the box has a few scars or dents.
MAKE SURE POWER SWITCH IS TURNED -OFF- BEFORE CONDUCTING ANY ASSEMBLY OR
MAINTENANCE PROCEDURES.
ESTIMATED ASSEMBLY AND SET-UP TIME
Allow up to 30 minutes for assembly, not including initial charge time.
Allow up to 6 hours (Lead Acid) / 9 hours (Lithium) for initial charge.
WARNING:
DO NOT USE NON-
ORIGINAL PRODUCTS
WITH YOUR ELECTRIC
SCOOTER.
The scooter has been
built to certain design
specifi cations. The original
equipment supplied at
the time of sale was
selected on the basis of
its compatibility with the
frame, fork and all other
parts. Certain aftermarket
products may or may not
be compatible.
SAFETY SWITCH AT KICKSTAND
The EEC version of this model has a safety switch assembled at the kickstand that cuts the
power supply to the motor if kickstand is down. In order to activate throttle and motor function
always put kickstand up before starting your ride.
handle bars
mirrors (on EEC only)
folding lever
saddle
battery box
carrier
hub motor
front suspension
horn (on EEC only)
5
