SXT-SCOOTERS
ASSEMBLY AND SET-UP
WARNING: Always dis-
connect your scooter from
the charger before cleaning
with liquid.
Note: If your charger does
not look like the one illust-
rated, your unit has been
supplied with an alternate
one. The specifi cations and
charging procedure would
not change.
The charger has a small
window with one LED or two
LEDs to indicate the charge
status. Refer to the illustra-
tion on the charger unit for
the actual „charging“ and
„charged“ status indications
for your charger model.
Chargers have built-in
overcharge protection to
prevent battery from being
over-charged.
Charger will get warm during
use. This is normal for some
chargers and is no cause
for concern. If your charger
does not get warm during
use, it does not mean that it
is not working properly.
WARNING: Failure to
recharge the battery at least
once a month may result in
a battery that will no longer
accept a charge.
Charging the battery
Your electric scooter may not have a fully charged battery. Therefore its a good idea to
charge the battery prior to use.
• Initial charge time: 6 hours (Lead Acid) • run time: up to 18 km (Lead Acid battery)
9 hours (Lithium)
up to 28 km (Lithium battery)
•
When the scooter is not in regular use,
recharge the battery at least once a month
until normal use is resumed.
Turn OFF power switch
before charging. Plug the
charger into the charger
port on the electric
scooter
Plug the charger into a
wall outlet. If the lights
on the charger do not
light up, check the power
outlet. If neccessary try a
diff erent outlet.
Charger
Charger
Port
Charger
Plug
Assembly and set-up
1. fold down
kickstand
2. Pull the folding lever located between left
and right handle bar
3. unfold handle bar pole
and lock folding lever
5. insert fuse before use
4. adjust handle bar height
and tighten screws
Seat assembly (if included)
1. lock seat holder on the
scooter
3. put the saddle and tighten
screws
2. place seat pole and adjust
suitable height
INSTRUCTIONS
6
