INsTrUcTIoNs
sxT-scooTErs
4
ASSEMBLY AND SET-UP
Install the scooter
WARNING:
Always dis-
connect your scooter from
the charger before cleaning
with liquid.
Note:
If your charger does
not look like the one illust-
rated, your unit has been
supplied with an alternate
one. The specifications and
charging procedure would
not change.
The charger has a small
window with one LED or two
LEDs to indicate the charge
status. Refer to the illustra-
tion on the charger unit for
the actual „charging“ and
„charged“ status indications
for your charger model.
Chargers have built-in
overcharge protection to
prevent battery from being
over-charged.
Charger will get warm during
use. This is normal for some
chargers and is no cause
for concern. If your charger
does not get warm during
use, it does not mean that it
is not working properly.
WARNING:
Failure to
recharge the battery at least
once a month may result in
a battery that will no longer
accept a charge.
1. put down
the scooters
kickstand
2. Press the
folded key
to unfold the
scooter
3. Lift the hand-
lebar and close
the key
4. Loosen
the screw
and open the
connector of
crossbar
5. Put the
crossbar and
tighten the
screw
Attaching the seat (if applicable)
1. Lock the seatbar tp
the scooter
2. Put the seatbar
and adjust the suit-
able height
3. close the
seat key
4. Put the seat and
tighten the screw
Charging the battery
Your electric scooter may not have a fully charged battery. Therefore its a good idea to
charge the battery prior to use.
• Initial charge time: 15 hours • run time: up tp 40 minutes of continious
• Recharge time up to 12 hours ride time
When the scooter is not in regular use, • average battery life: approx 250 charge /
recharge the battery at least once a month discharge cycles
until normal use is resumed.
Turn
OFF
power switch
before charging. Plug the
charger into the charger
port on the electric
scooter
Plug the charger ito a wall
outlet. If the lights on the
charger do not light up,
check the power outlet. If
neccessary try a different
outlet.
