INsTrUcTIoNs
sxT-scooTErs
7
TROUBLESHOOTING GUIDE
Problem
Short run time (less than
15 minutes per charge
Scooter runs sluggishly
Sometimes the scooter
doesnt run, but other
times it does
Scooter makes loud noi-
ses or grinding sounds
Possible cause
undercharged battery
Battery is old and will not
accept full charge
Riding conditions are too
stressful
Tires are not properly
inflated
Scooter is overloaded
Loose wires or connectors
Motor or electrical switch
damage
Chain is too dry
Solution
could cause the motor to overheat. If the scooter suddenly stops
running, wait a few seconds and then push the breaker to reset the
circuit. Correct the conditions that caused the breaker to trip and
avoid repeatedly tripping the breaker.
Charge the battery. A new battery should be charged for at least 18
hours before using the scooter for the first time and up to 12 hours
after each subsequent use.
Check all connectors. Make sure the charger connector is tightly
plugged into the charging port and that the charger is plugged
into the wall.
Make sure power flow to the wall is on.
Even with proper care, a rechargeable battery does not last forever.
Average battery life is 1 to 2 years depending on scooter use and
conditions. Replace only with a replacement battery.
Use only on solid, flat, clean and dry surfaces such as pavement
or level ground.
The tires are inflated when shipped, but they invariably will loose
some pressure between the point of manufacturing and your
purchase.
Make sure you do not overload the electric scooter by allowing
more than one rider at a time, exceeding the 176 lbs (80 kg)
maximum weight limit, going up a hill or towing objects behind the
scooter. If the scooter is overloaded, the circuit breaker may trip
and shut off power to the motor. Correct the riding conditions that
caused the overload, wait a few seconds and then push the breaker
to reset the circuit. Avoid repeatedly tripping the circuit breaker.
Check all wires around the motor and all connectors to make sure
they are tight.
Contact your local authorized service center for diagnosis and
repair.
Apply a lubricant such as 3 in 1™ or Tri-Flow™ to the chain.
